[Vogata]

We really can take it. Often the best solution comes out off several not so good ones. It most certainly seams like it on this end. We just finished one year off testing the last prototype off bottom drain. It’s the last off countless and we feel now the end of four long years. Its been tested alongside with others and now we finally got the one we once wanted to buy. We must confess that we are not that far on the filter bay side, but little by little….



What kind off mash do you use? We have maid some designed for mechanical strainer unit (not like yours inside an vortex). Have tried 50, 80 120, 200 and 400 micron. But even in a controlled environment, daily manned by Kichi’s like us they all clogged too quick compared to the TA400, which we run as a control unit on the same systems. The worst downside is the need for cleaning and growth in the mesh. Got a new type mesh in last week (have given up on AISI316). This one is normal used to remove small particles from paint. Hope to get better results with this one.

Are opting for a third line with solution soon but it would bee really nice with one off our own making that didn’t cut that deep in to a Kichi budget.