Polishing and Anodizing needed.

[frick655]

I have a few parts that need polishing and anodizing.

-First is an eaton supercharger. It has a stock grey powdercoating on it. I need the case and the snouth polished.
-Next, I have a "midplate." It is a relatively small piece compared to others listed. It goes between my intercooler and lower intake. I need this piece polished.
-Next, I have a lower intercooler intake for a 5.4 liter F150. This is a big piece. I need it polished...just externally
-I have a belt tensioner that I need polished.
-Next, I have a belt tensioner/pulley arm that needs polished. Pretty big piece that goes across the front of the engine.

I think that is it for polishing.

[JasPR]

Red, I'm so glad you brought your post here- first you need to remove the finnafit pin. Then polish the internal dractoid. After the dractoid is polished, remove the outer cover. Carefully, and I mean carefully, turn the ramification dial to the left one half turn, then anodize that section. That is all there is too it! If you prefer to have someone else do this, please mail it to me and I will bill you time and materials, Sincerely, JR

[jnorth]

Quote: Originally Posted by frick655 I have a few parts that need polishing and anodizing. -First is an eaton supercharger. It has a stock grey powdercoating on it. I need the case and the snouth polished. -Next, I have a "midplate." It is a relatively small piece compared to others listed. It goes between my intercooler and lower intake. I need this piece polished. -Next, I have a lower intercooler intake for a 5.4 liter F150. This is a big piece. I need it polished...just externally -I have a belt tensioner that I need polished. -Next, I have a belt tensioner/pulley arm that needs polished. Pretty big piece that goes across the front of the engine. I think that is it for polishing.

Quite frankly I'd have all coated with a flat black wrinkle finish so it dissipates heat better. If this is a fresh install you'll need any of the aftermarket software to recalibrate the computer. But since this is a koi board and I'm a naturally aspirated Chevy guy...this thread is closed.